I applied through university. The process took 1 day. I interviewed at Texas Instruments (New Delhi) in Aug 2016
Interview
At first they conducted an online test. this consisted of three parts-Aptitude,Analog and Digital.
then there were two technical rounds . First technical round span over a period of around 25 minutes. Around 55 students were shorted listed after first round which filtered to 8 student after first technical round. In the final technical round they shortlisted 6 students followed by technical round.
Interview questions [1]
Question 1
They basically asked about question related to RC and LC circuit ,op amps related questions.
Questions relation to bode plot and lead lag compensator. there were also question related to
CMOS circuits and seconds order equation relating network analysis
Online Assessment followed by 2 rounds of technical interviews. Online Assessment consisted of 3 parts - Analog, Digital and Aptitude. Analog part mostly consisted of questions from RC circuits, Opamps, MOS Circuits, Oscillators.
I interviewed at Texas Instruments (Bangalore Rural)
Interview
I am only having only one round of interview
Where they asked mostly about rc circuits. Op amp basics and mosfet questions.
The interview almost happened for 1 hour and it is a good experience
Keep your basics clear and intuition well prepared. Knowledge in RC and small signal is must. Himangshu Agarwal and Chembiyan T must and basics of opamp etc. Input and output impedance calculations etc.